Thomas77GR Posted October 30, 2011 Share Posted October 30, 2011 Hi I have removed that metal arm that the gas pedal sits on to weld the bulkhead behind the servo and the exact spot where that thing bolts on (there's a plastic plate with three screws) however after a long restoration effort I have come now to refit that and am not sure where it went! doh! Could someone please email me a couple of photos to help me with the above? I am looking for a)where in the footwell the plastic plate screws in and the way the arm sits under the plastic gas pedal email to tbamp77 at hotmail dot com thanks a lot guys, help appreciated Quote Link to comment Share on other sites More sharing options...
mantadoc Posted October 30, 2011 Share Posted October 30, 2011 Somewhere in here at the bottom ofpage 2 but the best hint I can give is if the cable at the top is lined up with the whole in the bulkhead for the cable the rest is obvious. Quote Link to comment Share on other sites More sharing options...
mantasrme Posted November 2, 2011 Share Posted November 2, 2011 Here is a picture to help (was taking some of a new project today and remembered this question) With the top lined up with the hole so the cable has a straight run the pedal should be level with the other pedals. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.