Jump to content

Single Wiper Conversion Scuttle Panel

Kevin Abbott

Recommended Posts

I did this many many many years ago so it has some rust rash but is sound

The wiper holes have been removed and the middle one repositioned in the centre of the scuttle panel

The old holes were butt welded and lead filled, this item needs finishing ( as the pictures show unless you are reading this in braille )

The motor underneath is from a fiat uno if i remember correctly and may need something or other doing to the circuit board but if you contact Gary Watson, Mantamorfin, asifimbothered ( same dude) he will tell you what it was as i can't remember

£20 plus post or collect from my house in Weir NW England




Link to comment
Share on other sites

It is all spot welded on so quite easy once you identify the spot welds you need to drill out.

The hardest part is putting a decorators scraper down the back of the spot welds on the windscreen bottom edge as it is 3 sections welded together and you only have to split one off. You put it in and hammer it across to break the bits that the spot weld drill misses.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...