Jump to content

Robert Boardman

  • Posts

  • Joined

  • Last visited

Profile Information

  • Location
  • Name

Robert Boardman's Achievements


Rekord (2/8)



  1. Hi Brought a manta hatch 20 injection 1986 which had fuel problems i now got it running but due to all the pipes being removed from tank i can't figure out what all the outlets are for. Theirs to small outlets on the top of the hump section which are rusted. They are joined together with a T section the centre of the t section is connected to the top of the filler neck. Can i block these outlets on the tank as they seem to be doing nothing? Theirs another small outlet on the hump, where does this go? On the top of the flat section on tank theirs another small connection, where does this go? And on the rear is another small outlet near the corner just below the seam. Where does this go? On the neck is another small connection, is this the breather pipe connection that is clipped around the edge of the tank and assume just ends at the rear. Has anyone got a drawing where all the pipes go? Sorry about all the questions. Rob
  2. I bet it wasn't april though. lol That pump is the same. Managed to get mine open and repair the plastic bit that drives the pump. Am sure mines working now. Hasn't anyone tried a pump on the bench in some liquid and a voltage supply? Or is their anyone who has a pump that could try this test. Or even anyone know if you short the fuses out to get pump running in car with the fuel line disconnected where it come through the wing, does fuel squirt out constantly. cheers so far
  3. Hi This one hasn't got a fan. Had the pump apart and it has four short steel barrels that rotate around a steel circle which were jammed. The pump looks like this one on ebay http://www.ebay.co.uk/itm/300840601750?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649
  4. Hi Has anyone tested a fuel pump by just puting pump inlet pipe into a tub of water. Reason i ask is my fuel pump went faulty but after spray some wd40 into it i could hear it running again, but still no output of fuel. So i tested it by putting the inlet into some water but even though i can hear the motor running it still doesn't spray water out of the outlet. Does it need tank presure to startup? I tried filling the inlet and outlet pipe full of water but still no output. cheers Rob
  • Create New...