paul691 Posted August 27, 2013 Share Posted August 27, 2013 I'm all done with this, both my chassis legs are good as new. http://www.ebay.co.uk/itm/171114789566 Quote Link to comment Share on other sites More sharing options...
robah Posted August 27, 2013 Share Posted August 27, 2013 Very nice piece of kit you had made there. Should come in handy for someone now. Quote Link to comment Share on other sites More sharing options...
Kevin Abbott Posted August 27, 2013 Share Posted August 27, 2013 Did you take your legs off, repair them and then put them back on or did you put new ones back on? Looks good, where did you prop the car up when removing the leg? Quote Link to comment Share on other sites More sharing options...
paul691 Posted September 2, 2013 Author Share Posted September 2, 2013 right had leg was a complete replacement, GM leg I picked up new a few years back. Left had was a Dr Manta kit with the reinforcements. I made the jig before I cut out my old legs so I could keep the fitment holes in the correct place while fitting the new legs. I did one leg at a time and the car was supported on the jig, rear chassis legs, chassis crossmember, sill, and on the leg I wasnt replacing. All went smoothly, fitted very well. Quote Link to comment Share on other sites More sharing options...
paul691 Posted September 2, 2013 Author Share Posted September 2, 2013 I need to start a thread in the project section. Ive been working on the car on and off for 6 years Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.