Jump to content

correct tool for job - removing manifold (inlet/exhaust) bolts


Recommended Posts

8 hours ago, Thomas77GR said:

I have two sets of 1/2" spline torx bit sets but neither was/is a 100% fit, so I now have slightly rounded one of the bolts.

I have a set in the garage, if I remember I will post a picture tomorrow. But you are correct they are not torx.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...