Cleaning Up Floor Pan For Medial Blasting

[Mototechnics]

I'm stripping my shell for media blasting and want to cut down on the labour cost. Any tips on getting off the black stuff stuck to the passenger and driver's footwell . Cheers, Mark

Edited October 9, 2011 by Mototechnics

[upk]

I'm stripping my shell for media blasting and want to cut down on the labour cost. Any tips on getting off the black stuff stuck to the passenger and drivers footwell . Cheers, Mark

hot air gun and a scraper!

Edited October 9, 2011 by upk

[simon p]

hot air gun and a scraper!

agree. I see you're in Norfolk, where are you having it blasted?

[Mototechnics]

Hi Simon.

Not researched it fully yet but heard good stuff about Retro Power's service. Any suggestions nearer home (Ashill, between Watton and Swaffham) welcome.

Mark

Edited October 9, 2011 by Mototechnics

[biffy1984]

I used a needle gun to remove my black stuff. A bit rough but did the job in about 10 minutes.

Cheers

Peter.

[Shug]

I used a chisel and hammer. Came off in chunks then an angle grinder for the residue.

[simon p]

Hi Simon.

Not researched it fully yet but heard good stuff about Retro Power's service. Any suggestions nearer home (Ashill, between Watton and Swaffham) welcome.

Mark

PM sent.

[mickappy]

easiest way i found was heat the underside of the car with a blow torch to warm the floor up and the

deaden just peels off soo easy:) took us a most 10 mins. car was upsidedown tho on a spit tho.

its a shitty job with the underseal tho.

[Retro Power]

Yea big propane blow torch works well.

Think simon's messaged you already, was going to suggest as I know he gets media blasting done locally to him and he's a lot closer than dragging it over here